Recently I did something dumb. I forgot to unhook my shore power. When I returned to my boat slip the yellow electrical cord was in the water. I shook it out and dried it out with a low temp heat gun. Before I hooked up the shore power I used dia...
Has anyone sourced a replacement for the small LED light located at the top of the breaker panel in the salon? (on our 2006 Sundancer 320). Also, is the switch for the cabin courtesy lights supposed to turn that one on? TIA
I just purchased a 1994 Sundancer 300 and the accessory breaker keeps popping out on the cockpit panel. What systems are powered by the Accessor rocker switch?
Hey everyone,my name is Chris and i am from Austria. I would like to install 2 underwater lights. Did you know if the cables from the helm to the back is already installed?there is also a fuse with cables but i don't know where to find the cables in ...
Hi all, I recently bought a 2005 260 Sundancer that has a lot of play in the steering wheel. I can rotate the wheel about 30° before the steering cable starts to move. It appears that the rack on the end of the steering cable and the pinion at the ...
Does anyone knows how to operate diesel cross feed valves between the engines. There are three valves one for PORT one for STBR and one in the middle. There is motor under the valves but we cannot find where the switch is located. On the dash there ...
Need a starboard side windshield for a 2012 Sundancer 28. Any help would be greatly appreiciated.
hello all,I recently installed 3 underwater lights and trying to hook into starboard helm pad ACC1. That pad is a sealed pad so hooking into can not happen. There is a 4 prong wire from pad down to another connection and then from there it goes to a ...
I just bought a 1999 380da. Looking for tips on how to install tv bracket on my port side cockpit area.
We have a 15-year-old 44' Dancer with some type of "fake teak" flooring throughout the cockpit and swim platform that is stained and weathered. Looked into replacing it, but the cost was out of sight. Any suggestions on how to clean (some have said...
