I've had a 93 180 bowrider for a few years. last year it started leaning and pulling to the left when underway. Could both these issues be caused by my hydrofoil? I bought a trim tab fin. can I use the hydrofoil and fin together? Just looking for adv...
Hi, my throttle & shifter unit (part number 819920 ) has given up & I need to replace it. Any suggestions please for a compatible unit
Can anyone confirm on a 2003 to 2006 that the helm seat rotates 90Degrees to form a chaise lounger with the double helm campion bench?
Good evening,I’m interested in replacing the original Quicksilver side mount control with trim feature. The throttle only button has failed and a repair of the original does not look like a long term solution. If anyone could advise on an appropriate...
As I continue my rewiring project, I'm down to four (original) wires in a Sea Ray harness, all four of unknown purpose.All enter the harness and then disappear into the hull, going .. who knows where. They areBlue with white stripe Green with white...
I'm redoing the wiring on my old SeaRay, pretty much top to bottom. The original wiring was only so-so, age and salt air has certainly taken a toll and the numerous "improvements" by previous owners are comical at best.Step 1 is tracking down every ...
I have a 1988 SeaRay Bowrider with a 100hp Johnson 2-stroke, and I am having issues with the throttle/shifter not getting to max speed/RPM and the Idle lever being so lose as to be useless. How do I adjust, or even what can I buy noew to replace thi...
I have a 1989 bowrider with a 135 Mercury 2 stroke outboard. I am having some issues with alarms. When I took it out the first time there was a long consistent alarm. We messed with the oil reservoir connection and that seemed to eliminate it that...
Just bought a 2005 220 select bowrider, with 350 Magnum bravo three, only 260 hours. Been running fine, no problem until other day when alarm went off and said fault oil pressure on Smart Craft display. The analog gauge showed about 55-60 psi. Alarm...
Hi everyone,Wondering if anyone knows what the wire size is for the green ground bonding wires on a 95' Sundancer 300? My bonding ring lug for the stern anode broke off and I'm looking to replace the wire and the ring lug. I looked on the wires I c...
