I have a 2003 280 Sundancer. I've...
I have a 2003 280 Sundancer. I've put NEW engine gauges in and NEW senders, but still get no temp indication on one engine and no oil pressure on the other. Checked continuity good. Any suggestions?
I have a 2003 280 Sundancer. I've put NEW engine gauges in and NEW senders, but still get no temp indication on one engine and no oil pressure on the other. Checked continuity good. Any suggestions?
I have a 2010 310 sundancer, the tv in the mid cabin has speaker problems, I can not see how to remove the tv. Does anyone know how to remove it. Billy
2009 SEA RAY 350/370 RPM & PROP QUESTION I own a 2009 350 / 370 Sundancer with Bravo 3 Axius stern drives and 496mag engines . When I plane the boat at full throttle the max rpm's I get from each engine is about 3900-4000, the boats max speed is 38-...
1996 - 370 SUNDANCER STOLEN My friends Sea Ray was stolen last night (Sept 26, 2017) around 5pm from the Gananoque Municipal Marina in Gananoque, Ontario, Canada. The boat has recently been purchased by my friend and his wife and they had just compl...
Anyone interfaced a simrad mfd to vessel view or directly to engine ECM? 2003 29' Amberjack, twin 350 Horizon V-drive.
I have a 2012 370 Sundancer. The starboard gas tank needs the gas gage float replaced. How do I access it, to remove the long float rod? It appears the cockpit refrigerator may have to be removed to access. Does anyone know?
I have an 05 340 Sundancer. The SMARTCRAFT display Brightness setting is stuck and I cannot adjust it . I can adjust the Twilight setting but not the Brightness. My display is dim and I cannot even see it at night. Any suggestions?
2003 Amberjack 290. Issue with STBD fuel tank guage. Fuel gauge reads correctly when first powering up/starting engine. While underway, the needle is all over the place, sometimes reading Empty, 1/2 or 1/4 full, etc. I can confirm that i had ap...
2013 370 Venture. Does anyone know where they 'hid' the amplifier for the Sony stereo system. They show it in the wring diagram but I have removed every panel that I can find and do not see it. It would make sense that they should have put it behind ...