Community Connection

I’d like to reupholster the front...

I’d like to reupholster the front birth of my 2009 31 Sundancer. In addition to reupholstering the side bolsters and the mattress, I would like to upgrade the quality of the mattress, but the thickness is limited by the side bolsters it slips under w...

Thanks, I'll have a look.

access to salon air conditioner on 1997 420AC

Need to service salon AC. For full access to unit, tech says stairs from salon to galley need to be removed. Attempts to completely remove stairs have failed. They can be partially lifted but that is as far as we get. Has anyone dealt with this befor...

Hello, I have a 2003 220 BR. I...

Hello, I have a 2003 220 BR. I am looking for schematics that include the molded accessory panel(bilge pump, bilge exhaust, lights, horn, etc.) on the lower right of the dash. I am also looking for the part itself or someone who rebuilds them. The ...

I have a (New to Me) 2017 SDX 220...

I have a (New to Me) 2017 SDX 220 and was wondering if anyone knows if Sea Ray pre wires their boats for all options in the factory, even if they are not installed. For example: the boat currently does not have docking lights installed but would the...

I have a 2002 260DA with a Westerburg...

I have a 2002 260DA with a Westerburg generator. The generator will crank and run for about 4 or 5 seconds but will soon stall out. Has anyone had any of these problems with this generator. I assume it is fuel related. The generator had low hours ...

Water in the bilge

Hello all! I have a 2009 210 Select I purchased in June. Over the summer we've replaced a few issues found along the way and now I'm down to a small leak somewhere. After a day on the water I end up with a few gallons of water in the bilge. I've trie...

Sea Ray

Conversations