Sea Ray

Thanks for your reply .Pic is a good Idea will post.It is running the correct way just think it was a poor design.I put a piece of a cut out plastic bottle that helped a little but not great and looked dumb.Hoped others had this problem and came up with good fix. Thanks will post pic.

Hope someone can make out what these pics are and may have an Idea

Thanks for the pictures.

From the description and the images, it the desired water flow to exit over the side away from the boat, straight out from where the channel exists?

Is the problem what the water passes through the channel, but then runs down, wrapping around that curved fiberglass, then drips into the cockpit below?

Yes that is the exact problem. Over the years it rotted the wood in the cockpit. We have replaced the wood but the problem still exists.

My suggestion is to use a rectangular thin section of white plastic, such as a Bondo blade, about 2-3" wide, attached to the top surface of that upper rub rail, extending several inches away from the boat.

The top surface of that upper rub rail already slopes downhill, good.

The water must be directed to only exit over that new ramp, not taking an easier path to still drip inside.

It should be possible to create "berms" of adhesive, on either side of those existing water channels, onto this new ramp, to the edge of the ramp.

The water should then run downhill on the ramp, then overboard when it reaches that lowest sharp edge.

If this works as desired, then a better appearance solution could be implemented using off-the-shelf self-adhesive trim parts.

Thanks for the idea, have tried a cut up water bottle and appeared to work, but looked really bad.Your Idea is a good one thanks for the help will have to look for a good looking solution.



thanks again