Good evening everyone! I have been looking to purchase a mooring cover similar to the outer armor ones for my SLX230. However I am having troubles finding a supplier. Does anyone have an idea of who/where I can get an OEM one?
Good evening everyone! I have been looking to purchase a mooring cover similar to the outer armor ones for my SLX230. However I am having troubles finding a supplier. Does anyone have an idea of who/where I can get an OEM one or do I just need to g...
Recently I did something dumb. I forgot to unhook my shore power. When I returned to my boat slip the yellow electrical cord was in the water. I shook it out and dried it out with a low temp heat gun. Before I hooked up the shore power I used dia...
I have a 2003 Searay 185OB srx. Going to be a simple question. Which way do I turn to remove the fuel water separator filter? I had it serviced and it's so tight . Usually left to loosen and right to tighten but not sure this is case?Thanks
I I currently have a 2019 searay SPX 230 OB, it came from the factory with a Simrad G05 chartplotter. The screen is so small. I can’t see it so I purchased a GO9. Does anybody know if I can just plug and play with this since it’s the same manufacture...
Hello. Im a proud new owner of a 2011 260 sundeck. When I tried to empty the waste tank which was showing “full, do not flush”, at the marina, it only pumped out about 1/3rd of the waste. The indicator now shows 1/2. The suction of the pump at the ma...
Has anyone sourced a replacement for the small LED light located at the top of the breaker panel in the salon? (on our 2006 Sundancer 320). Also, is the switch for the cabin courtesy lights supposed to turn that one on? TIA
Just purchased a used 2016 250 SLX with the motorized submersible swim platform. When its in its stored position the lower part of the platform is not completely secured and flaps up and down an inch or two. Boat is in the water so I can't get a visu...
My fuel gauge is not working and I found a loose ground wire in the fuel tank compartment. I jumped a wire from it to battery ground and it still does not work. Any thoughts?
