Community Connection
Advice and support from fellow boaters
cancel
Showing results for 
Search instead for 
Did you mean: 

Conversations

Hi all - I have a 2016 230 SLX...

Hi all - I have a 2016 230 SLX without the dynamic running surface trim tab system - would anyone know if this can be installed - and is there a part number for this kit? Tried to measure for aftermarket trim tabs - and not enough area to make anythi...

I have a 320 Sundancer, the port...

I have a 320 Sundancer, the port gas gauge only shows between 1/4 & 1/2.  When I power the boat down the gauge goes down to empty like normal but when I power it up it stops between 1/4 & 1/2, would that be the need on the gauge sticking, the gauge f...

Gbatt by Guest Contributor
  • 1346 Views
  • 2 replies
  • 0 likes

I Have a problem with my 2010 sun...

I Have a problem with my 2010 sun deck 260 (350 mag) and the mechanic can’t find the trouble. Getting a low water pressure alarm when running at higher throttle. They left the sensor unplugged until they can figure it out and said the other monitors ...

MDM1 by Guest Contributor
  • 738 Views
  • 2 replies
  • 0 likes

I have a 2018 SPX 210.  This year...

I have a 2018 SPX 210.  This year I started noticing that my white vinyl seats are losing their shine.  In some cases there is what looks like dirt on the seats that can't be washed off no matter what I use to scrub them.  I spoke to some folks who s...

dc80028 by Guest Contributor
  • 1341 Views
  • 5 replies
  • 0 likes

Hello Everyone, Can any of you...

Hello Everyone, Can any of you Sundancer 260 owners tell me how many miles per hour you getting out of your boat motors? I have a 2008 with a 6.2L and am only getting just under 30mph out of the thing at 4600 rpm. I know its a heavy boat but would th...

Scoobie by Guest Contributor
  • 8007 Views
  • 30 replies
  • 1 likes

fuel throttle lever adjustments

Need information as to "How adjust Fuel Thrrottle Levers"2001 Sea Ray 450 EB - Fuel Throttle Levers are out of sync -i.e. Port engine running at 1500 rpm Lever is pushed forward to approx 50% lever position  ....where as:Starboard Lever at 1500 rpm i...

Chubby by Guest Contributor
  • 329 Views
  • 0 replies
  • 0 likes

Hey folks. Can we have a conversation...

Hey folks. Can we have a conversation on teak. I have a bunch on my 55 and even though we wash the boat weekly the teak is spotted or dirt stained. We think it is trees as well as regular use. My question is once I clean it what success have you had ...

RMS by Guest Contributor
  • 911 Views
  • 3 replies
  • 0 likes