Sport Boats
cancel
Showing results for 
Search instead for 
Did you mean: 

Conversations

I have just purchased a 1995 180...

I have just purchased a 1995 180 and am having real difficulty understanding how to get the back to back seats to lie down. I have tried to follow the directions in the manual (loosen outboard screws and then pull seats apart) but is just doesn't hap...

TND by Guest Contributor
  • 707 Views
  • 2 replies
  • 0 likes

I purchased a 2015 270 Sundeck...

I purchased a 2015 270 Sundeck new this past spring.  Love the boat overall!  I have had a few problems with the boat, all happily fixed under warranty by marine max.  I am noticing a gas/fumes smell by the stern of the boat ever since the last repai...

tonkawood by Guest Contributor
  • 223 Views
  • 0 replies
  • 0 likes

I have a new-to-me 2008 240SD with...

I have a new-to-me 2008 240SD with Bravo III drive.  At around 3300 RPM I feel the drive begin to shudder (I can feel the vibration in my feet) if I begin to raise the drive out of "full down" trim.  The U-joints and gimbel are brand-new.   I was tol...

Kevin7 by Guest Contributor
  • 1078 Views
  • 3 replies
  • 0 likes

I am looking at getting a new prop....

I am looking at getting a new prop. Have 2006, 185 sport with 4.3 merc. I have a 14 X 21P on it now, but I really don't need the top speed, would like to get more hole-shot, plain quicker and pull tubes and skiers. I am looking at the Mercury "spitfi...

3Stripe by Guest Contributor
  • 717 Views
  • 0 replies
  • 0 likes

I am looking at getting a new prop....

I am looking at getting a new prop. Have 2006, 185 sport with 4.3 merc. I have a 14 X 21P on it now, but I really don't need the top speed, would like to get more hole-shot, plain quicker and pull tubes and skiers. I am looking at the Mercury "spitfi...

3Stripe by Guest Contributor
  • 990 Views
  • 3 replies
  • 0 likes

My 280 is a 2004 model sundancer,...

My 280 is a 2004 model sundancer, When i start the kohler generator it will run for approx 10 min and shut off, I restart it and it does the same everytime, I have serviced, replaced impeller, checked wires, ect, any ideas???????

Kona-Kai by Guest Contributor
  • 814 Views
  • 2 replies
  • 0 likes

I need to remove and reseal the...

I need to remove and reseal the bilge plug flange on my 07 200 Select. Any suggestions for removing and reinstalling the through hull nut and bolt securing the grounding wire?

Another 300 slx question. The trim...

Another 300 slx question. The trim tabs don't seem to be functioning. When planing the boat has some starboard side 'lean' which I try to adjust with the trim tabs. The digital indicator stays at 0 on the engine displays when I adjust either one of t...

My husband and I just purchased...

My husband and I just purchased a 2016 21 SPX.  Since day one, which now I wish we had not taken possession of it, the storage compartment under the dash on the port side continues to remain wet from water leaking.  We have taken back to dealer three...

McKinneys by Guest Contributor
  • 535 Views
  • 1 replies
  • 0 likes