Brunswick Community

I have an accessory switch installed at the helm which is wired up for the hydraulic swim platform option aft at the transom (switch connection installed at the fuse block under the helm), only the option itself was not installed. With the wiring in ...

The hatch cover in the floor of my 250SLX is warped and rises in one corner towards the rear latch lock about a quarter of an inch. I have tightened the latch lock as far as the play allows. Any further attempted adjustment to the lock is not an opti...

I have an SLX250 with the above panel control and indicator panel (same as on the SLX270). My issue is the indicator should show EMPTY/HALF/FULL, but only shows POWER when I turn the key to on. No indication of the level in the holding tank.My questi...

I have an SLX250 with the above panel control and indicator panel (same as on the SLX270). My issue is the indicator should show EMPTY/HALF/FULL, but only shows POWER when I turn the key to on. No indication of the level in the holding tank.My questi...

I took my 250 Sun Sport out of winter sleep and it defaults into what Lenco calls 'Limp Home Mode'. I have checked that engine and GPS data appears on the NMEA2000 network, but can't get it out of this safety mode and can only operate the trim tabs m...