Brunswick Community

wingless · 05-28-2020

This topic shows my anchor locker upgrade, to repair delaminated gel coat and to make an elevated shelf so the rode does not sit on the bottom surface. This was a great improvement when I switched from the optional 200' all-chain rode that was includ...

wingless · 05-17-2020

Raw water cooled exhaust - required inspections These are the required inspections for boats like mine, that were built w/ raw water cooled exhaust and operated in salt water. My 2000 380DA w/ 454 MAG MPI Horizon engines had many undocumented mainten...

wingless · 03-21-2017

This topic shows the remote control caddy I designed and fabricated. This was secured using snaps to the interior of a galley locker door. It is soooo handy... http://forum.sailrite.com/remote-control-caddy_topic2767.html

wingless · 03-20-2017

This topic shows my custom dinghy storage / retrieval system for my nicely restored 1994 Edey & Duff Columbia dinghy w/ my custom dinghy enclosure. Now I finally have a useful one-person system to store / launch / retrieve my dinghy. http://www.theh...

wingless · 07-14-2016

My 2000 380DA has a sliding / telescoping ladder within the swim platform, under a door. There are metal parts between each of the three U-shaped telescoping ladder rungs. On my boat the metal parts deteriorated. Some parts fell off, other parts fail...

wingless · 06-26-2023

It would be best for the unattended boat for the AC/DC converter to remain plugged into power, to maintain the batteries at float voltage.If the batteries are flooded cell, then properly top off the level in all batteries and all cells using distille...

wingless · 06-25-2023

Assuming the inquiry if for the dripless seal on the 1999 450DA vee drive interior shaft.If all correct, then that part should get immediate attention / probable replacement. Do not continue operation until this is resolved.It may be that the driples...

wingless · 06-16-2023

Welcome to the forum.Why not post images that will permit better assistance to be provided?

wingless · 05-31-2023

YWThanks for the info.As a demonstration of my firm grasp of the obvious, please be very careful during disassembly as some of the parts at that location support the very heavy mass and it would be VERY BAD for it to experience an uncontrolled crash ...

wingless · 05-31-2023

Thanks for the update.The seat cushions will be a coated plywood base, with foam, plastic and fabric attached.The seat cushions are attached to the boat, usually w/ oval head stainless screws, using stainless finishing washers.The access to those ret...

Brunswick Community

User Statistics

User Activity

wingless' Custom Anchor Locker Shelf Topic

Raw water cooled exhaust - required...

This topic shows the remote control...

This topic shows my custom dinghy...

G.G. Schmitt & Co. Ladders

Re: Storage On the Hard

Re: Propeller shaft leak

Re: 1994 270 Sundancer Interior Panel Removal Ideas

Re: Aft seat on 2018 SLX 230

Re: Aft seat on 2018 SLX 230