Hi everyone. I have a 2005 Amberjack...
Hi everyone. I have a 2005 Amberjack 290. The port throttle lever is very stiff. Lubed and cleaned at helm; still stiff. Any advice welcome. Thanks.
Hi everyone. I have a 2005 Amberjack 290. The port throttle lever is very stiff. Lubed and cleaned at helm; still stiff. Any advice welcome. Thanks.
I have a 85 sedan bridge 340. The upper helm steering is extremely stiff and takes both hands to turn. The lower helm works ok. The upper also leaks shaft seal it spins easily and free when the fluid leaks out. When I refill it it is hard to steer. A...
Does anyone have experience changing out the shore power inlet on a Sundancer 280? 3 am the shore power shorted out and is melted to the shore power chord. The Electric lines are too short to pull out to replace. I know its a fantastic $50 part so I ...
I have a 2013 Sundancer 310. Any good source for bow cushions?
I have a 1999 Sundancer 400 that needs a new AC raw water pump and the label on the old one is in pretty bad shape so I can’t read the specs! Does anyone know the proper replacement? Also need a resource for the hydralic cylinders for the swim platfo...
Hi Everyone, I have a 2008 230 Select. While the top of my carpets are in good shape, the bottom black rubber foam-like material is disintegrating in some areas and leaving small black granules on the floor. Does anyone have a way to repair the bot...
Hi everyone I have a 2000 270 Sundancer with the 7.4 bravo 3 ever since I bought it the steering was always stiff I replaced power steering pump actuator cable is good still is stiff any ideas I would appreciate thank you
Hi all,I own a 1998 290 Sundancer and I recently pulled the westerbeke gen set out to have the backend repaired. The wires for the remote panel were removed without taken a picture or writing the sequence down. I have 6 wires that go to the generat...