Community Connection
Advice and support from fellow boaters
cancel
Showing results for 
Search instead for 
Did you mean: 

Conversations

We recently purchased a 2015 Sundancer...

We recently purchased a 2015 Sundancer 350. Looking for coffee making solutions. Obviously many options. Looking for good quality coffee. Suggestions obviously need to comply with the boats electrical system. Specific brands / model suggestions would...

SamFisher by Guest Contributor
  • 5534 Views
  • 13 replies
  • 1 likes

260 Sun Dancer (2000) - How to...

260 Sun Dancer (2000) - How to remove portlight window screen assembly so I can put in new screen material?  Anyone ever do this?  I think I have to pull the inner frame and window to get access but I'm looking for advice.  Thanks.

removing forward berth upholstery from bolsters

I would like to re- upohlster the forward berth on my 2004 300 Sundancer. Does anyone know how to remove the three fabric covered bolsters that line the starboard and port hull? The center bolster is just below the forward mirror.  I had no problem r...

Miatao by Guest Contributor
  • 385 Views
  • 0 replies
  • 0 likes

Mid ship bilge

I have a 2019 350 Coupe. I have water in the mid ship bilge below the rear berth and cannot figure where it is coming from.  I have checked my shower drain, sink drain, ac condensate lines and fresh water tank.  It appears to be rain water.  Is any e...

Bulldog1 by Guest Contributor
  • 368 Views
  • 0 replies
  • 0 likes

Hi- We have a 340 and I wondered...

Hi- We have a 340 and I wondered if there is some way to make a secure compartment on the boat.   We had some things in the cabin go missing last season and I'd like to resolve it.   Any suggestions?

TINA1 by Guest Contributor
  • 2811 Views
  • 10 replies
  • 1 likes

I've been planning to install an...

I've been planning to install an "in hull" transducer on my 2001 310 Sundancer. I was told that it won't work because Sea Rays have cored hulls.    Any thoughts? Is the bottom section of the hull cored, or solid fiberglass?R.G.

Genny by Guest Contributor
  • 6995 Views
  • 20 replies
  • 0 likes

2005 4.3 MPI Mercruiser Gimbal Bearing

Does anyone know if the gimbal bearing is sealed on a 2004/5 4.3 alpha 1 gen 2 mercruiser? Also, how often should it be greased/replaced? Just bought the boat and it has 330 hours on it so wondering if I need to be concerned about that and have it re...

77vetter by Guest Contributor
  • 386 Views
  • 0 replies
  • 0 likes