Community Connection
Advice and support from fellow boaters
cancel
Showing results for 
Search instead for 
Did you mean: 

Conversations

Here is a shout out for GG Schmitt...

Here is a shout out for GG Schmitt who built the ladder for my 390 DA.  I had a borderline issue with the ladder and they took care of it quickly and efficiently.  I had a great experience dealing with them.  Hard to find customer service like that a...

cbruck by Guest Contributor
  • 1054 Views
  • 3 replies
  • 1 likes

Adding a Bow Thruster on a 1998 370 Sundancer

We are considering this.  Just wondering if there is anyone out there that has this same year & model that may have added a bow thruster.  We're wondering where the access inside the boat was made.  Also would like to know what model and size thruste...

Rob_E_ by Guest Contributor
  • 459 Views
  • 0 replies
  • 0 likes

2003 Sundeck water pump

Hey all,I've got this boat with a 350mag/Bravo 3 setup and I'ts water pump time.  Up til now I've had the shop do it due to the fact that it looks like an absolute nightmare:  not actually rebuilding it, but getting it out and then back in.Anybody go...

BigToes by Guest Contributor
  • 421 Views
  • 0 replies
  • 0 likes

Installing fuel flow sensor on twin-engine boat

I'm planning installation of a single Lowrance NMEA 2000 fuel-flow sensor between the single-fuel tank and the electric valves on the two fuel lines on Sundancer 280. The valves have two separate hoses connected to the same tank. Since I'm interested...

boatereng by Guest Contributor
  • 1019 Views
  • 0 replies
  • 0 likes

I own an ’08 Amberjack 290. I am...

I own an ’08 Amberjack 290. I am the third owner. She has twin 5.0 liter Mercruiser engines mated to Bravo 3 outdrives. According to the ECM, the starboard engine has around 500 hours on it. I had a complete loss of compression in cylinder 2 in that ...

drsteves by Guest Contributor
  • 2243 Views
  • 6 replies
  • 1 likes

1989 SeaRay 340, companionway hatch...

1989 SeaRay 340, companionway hatch or door, has rollers.  I previously asked where I could fine these rollers and someone gave the info.  I ordered them and they are too big in diameter.  I need that site info again; and/or any other site where I mi...

marklgunn by Guest Contributor
  • 1076 Views
  • 2 replies
  • 0 likes

Recently have learned to enjoy...

Recently have learned to enjoy just setting a drift anchor out and slowly floating across the lake. Save a lot of gas that way. Have some questions.If I put out my second drift anchor will I move even slower?Have small rips in the drift anchors,(2" -...

Ren by Guest Contributor
  • 5860 Views
  • 13 replies
  • 0 likes

(Repeat from "The Stream")Question,...

(Repeat from "The Stream")Question, has anyone here set their boat up with a wireless network and moved away from traditional sounder type head units to a more table/laptop based system?

Drago by Rising Contributor
  • 492 Views
  • 0 replies
  • 0 likes