Legacy Models
Pre-2000 Models
cancel
Showing results for 
Search instead for 
Did you mean: 

Conversations

Hi All,I have a 37' Sundancer Express. ...

Hi All,I have a 37' Sundancer Express.  I have no swim ladder.  Looking for a recommendation.  Also, how would it be attached, there is no access that I can find for the attaching hardware. TIADave G

davitg63 by Guest Contributor
  • 846 Views
  • 1 replies
  • 0 likes

Hello, Almost done fully restauring...

Hello, Almost done fully restauring my 1974 SRV 220 but have had a fuel starvation issue.  Anyone have a tank diagram?  I had to cut an access hole in the deck over the pick up tube as I'm down to thinking there's either a check valve in the 90 deg c...

OntheRocks by Guest Contributor
  • 445 Views
  • 0 replies
  • 0 likes

Finally got our 1992 370DB up and...

Finally got our 1992 370DB up and running! 32 miles an hour and not even full throttle. Really enjoy the diesels. Having trouble getting fuel inland though. I have a question for anyone that has diesels and have Luger generator. Can’t seem to figure ...

Hillbilly by Guest Contributor
  • 457 Views
  • 0 replies
  • 0 likes

Hello,   I have a 1989 Searay Sundancer...

Hello,   I have a 1989 Searay Sundancer 250DA with a 7.4/V8 Bravo engine. When we bought the boat it was missing the outdrive. I’ve been trying to figure out what outdrive will work best or be comparable with the engine. I believe a Bravo 2 will work...

AcSm13 by Guest Contributor
  • 476 Views
  • 0 replies
  • 0 likes

Have a new to me 1990 Sea Ray 210BR. ...

Have a new to me 1990 Sea Ray 210BR.  I found these two pieces laying loose way back against the transom.  Where are these supposed to go, what is purpose, and do you have any photos showing placement?

JRuT by Guest Contributor
  • 2011 Views
  • 3 replies
  • 0 likes

I need to attach the depth sounder...

I need to attach the depth sounder sending unit that goes into a round pocket under the engine in my 92 Sundancer 270. The depth sounder is the. original unit.  Is it glued in or does it just sit therethanksstuart

Stu2 by Guest Contributor
  • 495 Views
  • 0 replies
  • 0 likes

Help needed.  I just put on a new...

Help needed.  I just put on a new starter and I seem to be missing the purple and yellow wire that goes to the left side of the cylinoid.  I didn't see it on the old started but watching some video's it seems as though I should have one.  Not sure wh...

GooseTx by Guest Contributor
  • 2510 Views
  • 7 replies
  • 0 likes

Recommendations welcomed: I’m slowly...

Recommendations welcomed: I’m slowly working on the wiring in my 1980 300EC. There were three (3) size 31 batteries in the engine compartment that I recently replaced (not hooked up yet though) and a single (1) 4d battery located under the helm foot ...

Help? We just purchased a pristine...

Help? We just purchased a pristine (could have just rolled off the line) 1982 Sundancer 245. Not our first boat, but our first SeaRay. Problem is- we have no idea how to lower the v-berth table. It appears to be the original table- but it is bolted t...

sevans by Guest Contributor
  • 889 Views
  • 1 replies
  • 1 likes