Sea Ray

Soldthefarm · ‎04-19-2019

As simple as may seem, the ladder of my 2006 260 sundancer has become harder and harder to pull out. Any suggestions?

baby · ‎04-20-2019

You can use a marine grease on the slides and some LPS 1 or 2
on the ladder portion. We lube ours reg. and have no problems.

Flacoconut · ‎04-21-2019

Ours did the same, we used it to get up on the boat on the trailer and slowly it bent it , finally had to replace and now it only gets used when it's in the water.

Soldthefarm · ‎04-21-2019

Thanks BABY & FLACOCONUT, ILLtry grease first. but afraid it might need to be replaced, Happy Easter

JohnnyG · ‎04-21-2019

Dealing with same issue and actually the ladder has been in the extended position from when i bought it last year and had to lean up against rear seat, tried everything but sadly have to look into finding a replacement

Soldthefarm · ‎04-26-2019

Never heard heard of LPS 1
& 2. I won't be without it. Did the trick, Thank you

Vinster · ‎05-26-2019

GG Schmitt and Sons should be your ladder manufacturer. Www.ggschmitt.com. You can buy the rubber slides and stainless hardware.

wingless · ‎06-13-2019

A ladder rebuild kit was purchased with all the screws and slides, now mine works / looks like new again.

Drago · ‎06-21-2019

wingless, where did you find the kit?

wingless · ‎06-21-2019

My boat has this G.G. Schmitt & Sons ladder.

http://www.ggschmitt.com/ladders.htm

They sell a rebuild kit w/ ALL the required parts to restore like-new operation.

Sea Ray

As simple as may seem, the ladder...