I have a 2015 Sundancer 370Looking...
I have a 2015 Sundancer 370Looking for feedback on Mercury vessel view mobile. Has anyone installed? Feedback?
I have a 2015 Sundancer 370Looking for feedback on Mercury vessel view mobile. Has anyone installed? Feedback?
For those of you with a Sundancer 320 V drive or similar models who struggle to work in the incredibly cramped engine room, I thought I should share my solution that has made my access so much better. I have installed a 10” wide diamond tread plate ...
Seadek or other synthetic flooring. Does any one have any suggestions. I have a 29 ft. Amberjack and I wanted to do the inside cabin.
496 Mag Oil Pressure question. I have a 2009 350/370DA with twin 496s at about 650 hours each. They run fine and have new oil changed this past spring using Mercruiser synthetic and are both full. At idle, the There is an oil pressure difference of a...
Calling all those who have painstakingly removed gauges and updated dashboards. I have replaced dash, reconnected and re wired my gauges on my 98 330 DA and everything works with the exception of the gauge lights which have never worked when I turn o...
Hello Folks - Looking for recommendations concerning A/C for my 1990 Sea Ray 350 Express Cruiser. It is not a retrofit but a new installation as it was never equipped from the factory. Looking for recommendations re: manufactures, BTUs (I am thinking...
Has anyone got any knowledge or, better yet, experience, with "Marine Power" replacement engines? I am experiencing extreme delay in getting engines from Mercruiser, & considering using them. What's the general opinion??
2007 260 Sundancer...where is the cabin fuse box? I blew the 12V DC outlet that is located under the microwave. I see the wiring harness in the manual and that it is a 15amp fuse but do not see the location of the fuse block. Appreciate any help!
I believe SR uses Pettit Hydro Coat
Does anyone know what kind of bottom paint Sea Ray uses from the factory? My boat is a 2003 Sundancer 300 and finally needs a new bottom paint job and I would like paint over with minimal prep.Thank You, Allen