Does anyone have any ideas about an overheating engine? 8.1L Mercruiser on a 340 Sundancer. So far, I’ve replaced the temperature sensor, the seawater pump, and the heat exchanger. The engine overheats after 20-30 minutes. Local techs haven’t been ab...
I have a1999 33 Sundancer I need to fasten bow rail any suggestions or how involved it is first 2 Stanton's are loose not sure how to access or what will be needed
I am considering adding the transom seat option to my 2013 330 Sundancer. Has anyone installed one of these? Anything I should be concerned about with the install? I love the storage I have back there but think the seat would be great at the dock and...
Looking for the ladder manufacturer for the swim platform ladder on a 2007 Sundancer 280. thanks!
I have an 1987 Sea Ray 300DB. and I am trying to repair the lower helm throttle cables. Would anyone in the Sea Ray club have an owners manual to allow me to access the throttle cables. Or if anyone in the Se ray Club has carried out this task. The t...
I have an AJ 29 re powered a couple of years ago withe same 5.0 mercruiser engines as the original. They are in perfect condition, always start. Out of the blue both engines would not start (but crank fine). I tried the next day and the same result. ...
Today, on our 340DA, my Koehler 5ECD ran perfect except when we used the micro. We noticed the lights in micro flickered, then tripped the micro breaker. Then, not using micro, We tried to use the stove, using both burners but that also tripped that ...
Hi there. Not sure if my post went through the other day or not as I can't seem to find it:) I just bought a 2019 Sundancer 320 OB and had a couple of questions from my learned colleagues:). 1. When the Mercury Skyhook is engaged, is there a way to...
Hi everyone - I have a 2014 330 Dancer and it has the annoying electronic horn/buzzing/prison escape sound. Does anyone know if this electronic module can be replaced with a normal horn sound?Thank you!
I have a 1998 Sundancer 270DASE (single 7.4L MPI, Bravo 3). It’s always been in fresh water and maintained very well. The bottoms of the exhaust manifolds are rusty to the point of thickness flaking off. There’s plenty of space for access since it’s ...
