Mente Marine trim controller
We put the Mente Marine automatic trim tab controller on our boat. Single best upgrade we have done so far.https://youtu.be/YPoIE6b9ri4
We put the Mente Marine automatic trim tab controller on our boat. Single best upgrade we have done so far.https://youtu.be/YPoIE6b9ri4
I need to replace the rocker switch for my starboard engine. The old one is Carlingswitch VM4J 10A 250VAC.1/2HP 15A 125VAC 670521.I believe it is an off/on/(on) double pole rocker switch w/jumperDoes anyone know where I can get a replacement or a...
Doing a radio upgrade can be intimidating for some, easy as pie for others.https://youtu.be/MWXomQ1ahPs
Hello. I searched transom doors - didn’t see anything. If this is redundant I apologize. on our 2006 Sundancer Sportsman after picking up for first time this year I noticed the plastic (excuse me o don’t remember the name) that are held in by 4 ro...
We have a 98 310 Sundancer. Last night I discovered a puddle of water beneath the aft berth in the corner closest to the head. The water had to of been new as the bedding wasn’t too wet and there was no mildew. After drying it up I tried running the ...
I have a 2004 360 Sundancer. The steps from the cockpit to the salon have stress cracks in the welds where the steps attach to the support pole. The first and third step are stress cracks but the middle step has begun to separate. Has someone expe...
Has anyone replaced the noise reduction foam on the underside of the engine hatch with thicker than the standard 1”? If so, did it make a significant difference?
360 Sundancer
Hey everyone,I'm having a fairly regular issue where my SeaRay Sundancer 280 (2017) beeps 6 times upon startup. After that, it runs fine. I've checked the manual and can't find anything regarding beep codes. Any ideas? See video below for example. h...
Hello All - I have have a 08 350DA with 8.1L Horizons V-Drives (I believe aka 496s) and would like to add smart craft Vesselview. I’ve called Mercury Marine directly and confirmed the engines are compatible. Has anyone on this forum installed this ...