I have a 2000 340 Sundancer with the 7.4 Horizons. The bilge blower vents, deteriorated, so I am in the process of replacing them. There are four on each side. The starboard side is for exhausting the bilge fumes with hoses leading from the port an...
Trying to get the A/C working in my 2003 Sundancer 240DA and am not finding a lot information out there at all. I did find the parts in the parts manual, but no diagrams as to where everything is located. Anyway, I did find the A/C compressor behin...
I have a 2005 SeaRay Amberjack 270. Recently purchased the VesselView Mobile interface. I cannot find the 10 pin connector with the yellow terminal cap. Its has a Mercruiser 496 Mag inboard. I've looked everywhere. Online it says most are locate...
After phone calls to both SeaRay as well as local dealers...no luck in getting info on how to remove the attached seat backs from my 27 Sundancer.No wonder...the boat is built in two sections, and then glued together after the entire area above the h...
From the Parts manual:Part Number 1319607 330EC 99, PANEL, BLANK:INSTHIN# 714550 GROMMET, SWITCH/GAUGE PANEL
First post!! Help please. Easy one: 95 300DA Sundancer with 3 batteries running bow to aft on the starboard side. Which battery is house battery? I assume: Rear bat = PortMiddle bat = HouseFront bat = Starboard Can a few people give some feedback ...
Hi all, We got to spend 3 days on our new to us 1990 310 Sundancer this past weekend. We even took her out yesterday and spent a couple hours just chillin on the water. I did discover a new problem that needs immediate attention though After giving...
Hi- new to the group so pardon me if this is already in the archives... I'm about to pull the trigger on a 2003 340 Sundancer DE- 8.1 Mercs, V-drives with only 300 hours. The boat is clean, clean, clean inside and out except canvas (ready for the dum...
Thank you will get into my manual and see what I can find on line as wellAllen
I have a 2003 Sundancer 300 and one of the trim switches on the throttle has failed and will not trim the out drive. I cheat and use the trailer tilt to raise both out drives at the same time and then the failed switch will bring the out drive down ...
