I have a 2018 190 SPX and am worried about brackish water being retained in the exhaust manifold coolers. Can anything be done to prevent rusting these out? Is brackish water nearly as bad as seawater in this situation? Thanks.
I have a 2002 Sea Ray. 182 Bowrider. The port side windshield and pass through window were shattered due to the flood at Lake LBJ. Thankfully no other damage. It was a Taylor made windshield.Can anyone tell me where I can get a replacement? It is on...
Hello, I am interested in adding a swim platform to my recently purchased 1989 220 Sundancer. I would like to build my own out of Starboard. Has any one recently done this on their own and does any one have the rear cutout demensions or pattern? T...
I have a 2006 WE225 with 5.0 Merc, 230 hours. When I start it cold, no problems. After a cruise and anchoring, the engine will not start when we want to leave. It coughs, sputters and pops, not quite like a backfire. It wont catch when in neutral. It...
PS to my last postAfter the cut out, we have taken very long rides without incident.
I have a 40 MY with Cummins engines. On 3 occasions after running perfectly, the starboard engine has just cut out. It will restart after a few minutes and have no other problems. Has anyone out there experienced this?
Hi. I have a 2011 Sea Ray Sundancer 260 that I recently bought that sat for several years and only had 120 hours on it. A local broker had it listed. Boat is immaculate (stayed covered on a boat lift). Been fighting typical stuff... replaced dry ...
Good Morning members!,i have a 2004 420 Sundancer.i have 217 Cummin motor’s.yesterday i turn off my motor’s and my port side motor stay on.my port side light switch stay on after several attempts on my cabin panel and my engine room panel.to shut dow...
