HELP!! Only some of the buttons on both port and starboard switch pads are functioning on my 2001 280 dancer. Anyone have a steer for me? I hear fp marine may have a fix as I dont think I can get there switch pads from SR anymore.
Question; 2018 230 SLX W the iPhone will not connect via bluetooth or cable. The message on the screen says to forget the SeaRay and re connect. I have done this several times and it locks the screen in a perpetual reconnect activity but never conne...
Anyone have a recommendation for a mechanic in the Boynton Beach/Lantana area of southeast Florida, Palm Beach County. A mobile mechanic from anywhere in southeast Florida would be fine. thanks. Mercruiser and electrical problems.
I have 4 A.C. on the biat with 1 1500 GPH pump, seems the manifold has 1 slow port of water movement I can't clear. Want to replace. Who has a replacement? 1" in x 4x 5/8" out.
Just an FYI. Anybody that has a mercruizer with the engine drain system and those little blue drain plugs. If you can’t remember when you changed them, it’s time to replace them. Just so happened that I went to my boat over the weekend and opened the...
I have a 2006 225 Weekender. The fixed port holes have a plastic trim oval that snaps into place. I have lost 3 or 4 trim pieces when a swell / wave hits the bow. Any suggestions how to better attach / fix the trim piece? Wingless, you gotta know. Th...
I have a 2015 270 sundeck with a head on it. We have experienced the base cracking at all the base bolts twice. Once replaced on warranty and again recently. Have ordered a new base to replace but looking for an installation method to avoid this happ...
I have a 29 Amberjack with a Mercruiser 5.0 engine. I've changed filters for my Gen 3 fuel cell a number of times but this time the lid w/ handle does not want to come off. Perhaps some corrosion is making it stick onto the fuel cell body (kinda feel...
Wingless is correct. My Searay 320 had the same issue. The wiring that goes to the solenoid Is the problem. I kept having the problem until I soldered the wiring and put shrink tubing over the joints to prevent any corrosion from forming.
