Hey folks i have an electric shade on the rear of my searay. it was not operating and am here to supply a web address for sure shade. they have some great videos if you ever need to fix their systems - worked for me in less than 1h. enjoy https://...
Greetings. My 3rd SeaRay is a 1997 Dancer 330 V-drive. Her two 7.4's are drunk on sea water. In my research, I learned that she has been repowered at least three times. And that scenario is not uncommon with this design/year/model/configuration. So i...
HI all New to this Inherited an older 1979 Searay 260 with a newer 1980's 350 Magnum Engine and I believe a Pre Alpha lower drive unit. Boat is in great Condition, But will not drop into reverse. I have already replaced the lower...
I have a 2008 SD280. In the marina it is stored on an uncovered outside ground rack. I have access to 110 power but not 240. I have an 110 adapter for my shore power cable but am not sure if that would work with my boat, specifically will it work wit...
Hi everyone. I have a 2005 Amberjack 290. The port throttle lever is very stiff. Lubed and cleaned at helm; still stiff. Any advice welcome. Thanks.
I have a 85 sedan bridge 340. The upper helm steering is extremely stiff and takes both hands to turn. The lower helm works ok. The upper also leaks shaft seal it spins easily and free when the fluid leaks out. When I refill it it is hard to steer. A...
Does anyone have experience changing out the shore power inlet on a Sundancer 280? 3 am the shore power shorted out and is melted to the shore power chord. The Electric lines are too short to pull out to replace. I know its a fantastic $50 part so I ...
I have a 2013 Sundancer 310. Any good source for bow cushions?
I have a 1999 Sundancer 400 that needs a new AC raw water pump and the label on the old one is in pretty bad shape so I can’t read the specs! Does anyone know the proper replacement? Also need a resource for the hydralic cylinders for the swim platfo...
