1. need to secure the protection change over switch on electrical panel 1988 345 sedan bridgethere are two of them. One has fallen off and the other is hanging loose. There plactic devices block ' turning on' both the shore power and shore brea...
I have a 08 27 SLX and need to replace the decals on the side of the boat by the exhaust. Does anyone know a supplier? I found one supplier on Ebay but they have been closed since July and not responding.SEA RAY PART# 1777921
Looking to compare notes with anyone who has a gen 1 Merc Axius joystick system. Any electronic gremlins that I need to be aware of? Any way to avoid? I was a little reluctant to move to all-electronic systems from traditional cables that I was used ...
I think I might be one of the few that purchased one of theses. I will say we had A LOT of issues the first year but the marina was great and resolved all the problems. It is a great boat. The bow and stern thrusters are game changers. Now I receive...
Hi I have a 2015 350 SLX anyone have suggestions on where to keep in dry storage in the Lee County, Fl area?
Where can I find more details about a 235 Weekender from 2011?
We have pink mould on the Port rear cockpit speaker panel trim,Does anyone know how to remove the panel so I can treat it.Thanks
Pre-launch checklist: does anyone have a detailed check list that the 1st mate and I can put on clipboard to use prior to launching? It should include everything: engines, fuel, electrical, safety, comma, etc. Also could use a version that has an hou...
Hi All,i amnew to the forum and excited about having a community of support. I have a Sea Ray 450 and after every trip I have to shop vac out between 10-15 gallons of water from the bilge. We notice that water is pouring in through the hatch when w...
Greetings! I recently bought a 2007 Amberjack 290 with inboards and v-drives. The boat is currently fitted with shaft logs/seals from Tides Marine. I believe they are known as SureSeals, but they have started to leak, only on the starboard engine, so...
