Does anyone know if the gimbal bearing is sealed on a 2004/5 4.3 alpha 1 gen 2 mercruiser? Also, how often should it be greased/replaced? Just bought the boat and it has 330 hours on it so wondering if I need to be concerned about that and have it re...
Hi! I have a 2006 Sundancer 40 w/gas inboards. The Starboard H20 pressure is 6 - 8 psi higher than the Port H20 pressure. The engine temperatures are normal and comparable. Any ideas for the difference in H20 pressure? Thank you!
Hey all,I've got this boat with a 350mag/Bravo 3 setup and I'ts water pump time. Up til now I've had the shop do it due to the fact that it looks like an absolute nightmare: not actually rebuilding it, but getting it out and then back in.Anybody go...
Hi AllI purchased a 2000 480 SEDAN BRIDGE earlier this year and she has been running fine but I have just encountered a problem where I cannot get the motors to rev higher than 1300RPM when in Gear. In natural they will rev to 2100RPM no problem.The ...
Looking for information on why my generator and starboard engine stall and won’t restart after running at cruising speeds but stall at idle and won’t restart.
Hello all, (PROP FOR 91’ 220 sundancer 350 mag 4bbl carb with alpha gen 2 drive?????)im trying to get the correct information for my vessel. Unfortunately my new to me 220 sundancer has to be Repowered,....AGAIN, first at 500 hrs(Hull good/orig engin...
Hello all,We have a 2018 SPX 210 for our first boat and are loving it. We’ve got about 46 hours on her so far this season.I am confused/concerned about fuel consumption. I know the specs say it holds 40 gallons but when reading E the most I’ve put ...
