340
340
340
I have a 2005 Sundancer 300. Recently I experienced a full waste tank and no pump out service available for 4 days. I was told to flush my tank in the river, that most boats had this option, but never found any such tool Is there a device tha...
On my amberjack 290, the ceiling panel pin fasteners don't hold. Any suggestions how to fix is greatly appreciated.
I have a 2003 amberjack 290. Trying to remove the galley table post to convert to a bunk.Any tips to dislodge as it is stuck in the mount which is covered by carpet
This cap is cracked. Can anyone tell me what part this is? Thank you! 2014 330DA 2014 330 DA - 350 Mag Seacore Bravo III
I have a 2008 280 Sundancer with hydraulic Bennett trim tabs and a Bennett TPI 2000 trim position indicator. I need to replace the TPI 2000 but Bennett does not make it any more. Any ideas on where I minght find even a used on in working order?
I have a 1994 Sundancer with 2-454’’s connected to 2-63 VF Hurth transmissions. (v drives). My exhaust manifolds and risers are junk and got water in the pan. Question is how is the engine coupled with the transmission. Is it splined with the flywh...
The power steering is usually run off the starboard engine which causes an increase in fuel consumption..Also, if you have 2 gas tanks and a generator, the generator usually runs from the starboard tank
Hi guys, this is such a great forum. I have a 2006 38DA. I’m looking to put 2 speakers in rear seating area by the engine hatch. I want to put one on starboard and one on port side. Am I safe to drill a 4”-5” hole in the gunwale. Very hard to see fro...
I have a 2015 SD 350 V Drive …my Kohler 5EKD generator is throwing an AF error code. Sometimes it runs for a while (2-3 hours) sometimes shuts down within minutes. Replaced 02 sensor. A buddy with a similar unit in his 310 says it might be the fuel p...