Anyone interfaced a simrad mfd...
Anyone interfaced a simrad mfd to vessel view or directly to engine ECM? 2003 29' Amberjack, twin 350 Horizon V-drive.
Anyone interfaced a simrad mfd to vessel view or directly to engine ECM? 2003 29' Amberjack, twin 350 Horizon V-drive.
I have a 2012 370 Sundancer. The starboard gas tank needs the gas gage float replaced. How do I access it, to remove the long float rod? It appears the cockpit refrigerator may have to be removed to access. Does anyone know?
I have an 05 340 Sundancer. The SMARTCRAFT display Brightness setting is stuck and I cannot adjust it . I can adjust the Twilight setting but not the Brightness. My display is dim and I cannot even see it at night. Any suggestions?
2003 Amberjack 290. Issue with STBD fuel tank guage. Fuel gauge reads correctly when first powering up/starting engine. While underway, the needle is all over the place, sometimes reading Empty, 1/2 or 1/4 full, etc. I can confirm that i had ap...
2013 370 Venture. Does anyone know where they 'hid' the amplifier for the Sony stereo system. They show it in the wring diagram but I have removed every panel that I can find and do not see it. It would make sense that they should have put it behind ...
REPOST - HELP12V Outlet In Cabin Not Working - 2001 280 Sun Sport: Purchased boat used. The outlet in the cabin has no power. It is located below the microwave and above the refrigerator; next to the AC outlet. The other 12v outlet is at the helm and...
'03 280 Sundancer w/ twin I/O 4.3 225 hp. I just replaced the manifolds and risers on the port engine. She sounds great now, but when I took her out for a test run, I discovered the port engine rpms peg to the max once I get over about 8 knots on por...
'05 340 Sundance with 8.1 Horizons. Last outing I noticed the port engine was slow to get to the same rpm (3450 cruise) as the starboard. It also required noticeably more throttle to match the starboard. Suggestions on where to start checking? Engine...
2003 amberjack 290 Newbie QuestionJust purchased my first twin screw I/O. I have dual 115 gal tanks. The STBD tank drains faster I believe as the gen set just draws from one tank.Is this also the case for each motor?Do they draw from only one tank ...
How do I get rid of the stinky smell when I turn on the hot water. The cold water is fine with no smell.