Hi,I have a refurbished 1989 Sea Ray 300 Sundancer Good Windlass for sale.I purchased a new refurbished one.After further investigation, I discovered that the old ones 12V engine simply needed the carbon brushes replaced and the engine cleaned. I fix...
Hi: I have a 2014 260 DA and I'd like to know the original color. I bought it used and found out after the fact that it had been vinyl wrapped. Current color is black. But I don't know what color is under the vinyl. Is there any way to find out from ...
Afternoon all, I am looking for any information in regard to adjusting the shift cable on an omc Stringer to allow the boat to start in neutral. Any direction towards a manual will be greatly appreciated. The manual I have talks about the shift needl...
I have a 2008 195 sport and It has a faulty depth finder. Readings are all over the map. My question is how do I test the transducer and where is it?Dan
Hello all, I have a 2007 sport and am installing fusion cones onto the tower. Has anyone done this, can you provide best practices for what worked for you…thank you in advance for your help
I need to have my QSM-11M starboard cooler and aftercoolers removed to service and fix a coolant leak on the heat exchanger. This is the “awkward” starboard side where space is very restricted. Is this job possible without removing part of the salon ...
I’m looking for ladder treads for my 2008 SeaRay 350, the brand is GG Schmitt. Called them and they only sell one type and those aren’t the right ones for my ladder. Anyone know where to purchase some? Thanks in advance. It’s a four step that folds u...
Hello, the steering on my 1994 270 Sundancer had been tightening up recently and is now completely locked up.I read the part number to be "SSC1342" (see pic below) though there appears to be an extra partial character. When searching for part number ...
Any ideas for how to clean red clay from the white seats of a 2018 280 SLX? Does anyone know if this boat has silicone based upolstery?
Hi everyone, I'm having trouble getting a new backlighting strip to work.. the old strip had 4 wires and the new unit that i bought from fpmarine has a transducer with 2 wires. How do connect these (2) wires? Any help would be appreciated.
