I have a 1990 310EC and I cannot...
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-10-2021 03:10 PM
I have a 1990 310EC and I cannot find any way to get gaskets for the windshield. They are leaking and becoming a problem. Anyone have the part numbers or similar issues?
5 REPLIES 5
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-10-2021 08:10 PM
I have tried looking as well. Seems all there is is aftermarket trial and error. Same with latches for the windshield vent on my DA. I plan on waiting until this garbage is over and my closest dealer is open again to ask the burning questions.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-11-2021 07:25 AM
The windshield was probably a Taylor Made product.
When the screw cover vinyl shrunk on my 2000 380DA i purchased identical material, sold by the foot, from Taylor Made, to effect a permanent repair.
When I replaced these parts I cut the ends at an angle, matching the cavity on the boat and cut to the maximum possible length.
At that time I also sequentially removed and replaced each screw, injecting sealant into each hole, prior to replacing the screws.
https://www.taylormadeproducts.com/hardware/screw-cover-vinyls/
When the screw cover vinyl shrunk on my 2000 380DA i purchased identical material, sold by the foot, from Taylor Made, to effect a permanent repair.
When I replaced these parts I cut the ends at an angle, matching the cavity on the boat and cut to the maximum possible length.
At that time I also sequentially removed and replaced each screw, injecting sealant into each hole, prior to replacing the screws.
https://www.taylormadeproducts.com/hardware/screw-cover-vinyls/
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-11-2021 08:14 AM
Taylor made has no records for size or type of trims and seals. There has been some that have taken the seal or gasket and matched up (sort of) with seals from places like Grainger. But they weren't an exact fit and needed trimming or modifying to get to sort of work.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-13-2021 04:21 AM
Boat
vent gasket p/n 8352000 5 feet required
3.30.21 Facebook post
Tony Ciero rubber for Stainless part # 8349040 bottom of windshield
Rubber for hinge vent
8229900
Both through Taylor Made
Above is a saved note shared by a fellow boater- thanks for reminding me of something else I should have ordered last winter😀
vent gasket p/n 8352000 5 feet required
3.30.21 Facebook post
Tony Ciero rubber for Stainless part # 8349040 bottom of windshield
Rubber for hinge vent
8229900
Both through Taylor Made
Above is a saved note shared by a fellow boater- thanks for reminding me of something else I should have ordered last winter😀
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-13-2021 05:09 AM
Thanks for the info! It’s nice to have people who care!