1998 270 SDA Sundancer. I ran an extension cord from the power outlet in the mid-cabin birth to my marina neighbor today and he dropped the outlet end in the water as he was trying to return it and now the power outlet does not work. I tried flipping...
Question about companionway door on 2021 320daHello everyone. I just bought a '21 320da. The companionway door is difficult to open -- from the closed position, you have to press the thumb button, pull it even more closed, and then push it open. O...
Fuel problem on 370. I have a 2010 370 with 496 B-3's with Axius. I had a fuel problem about a week ago when starboard engine just shut off. Limped back to dock and tried to figure out what was happening. Played with fuel solenoids, turn knob to ...
Hello all. I have a 2004 Sundancer 340. The rubber switch for the bilge pump at the helm is stuck in the ‘on’ position with the green LED light on. It won’t turn off when I press it. Hence the pump is permanently running even though the bilge is dry....
Has anyone purchased a replacement cord for a Northstar NS100 Marine Radio from Max Marine Electronics. If so, was it difficult to replace and does it work well?
Accessory panel 1810626 2007 280 Sundancer appears shot. Any ideas where to source one? Located in Long Island NY. Thanks!!
Looking for a replacement cover for 1999 Sundancer 260.
Microwave Oven. I have a 2003 Amberjack 290. I just can't figure out how to get the microwave oven out. There are two screws in the front at the bottom to hold a piece of wood trim in place. There are also two screws underneath close to the front tha...
I have a 2010 Sundancer 310. It has twin Merc 350's (300 hp each) and the Axius Joystick system. I have received an alarm on my Vessel View that I don't know what it means. The alarm is "Helm1 Starboard CCM: PadFault". I have Googled it several t...
1998 270 SDA Sundancer cabin door doesnt slide. Feels more like I am dragging it across the track then sliding. Rather certain the sliding mechanism is worn or broken. My understanding is that I will need to remove the helm control panel to access an...
