2010 370DA with DTS and Axius...Got a "SHIFT ERROR" and confirmed that the SB engine would only engage in reverse, but not in forward gear. Worse, sometimes it wouldn't disengage back to neutral. As a result, the boat was going in circles around itse...
2008 280 DA. Twin 5.0 L Sea Core Mercruisers. Kept on outside rack. Noticed slow oil drip from end of port prop. (Part of exhaust vent?). Would that more likely be leak from motor thru the exhaust or a lower unit leak?
2008 340, 8.1 V drives, bolt broke on port side motor mount. Engine shifted forward but ran fine. I only noticed because the gap between the strut and prop was much smaller than other side. This ever happen to anyone? Any advice? Also, Generat...
Just bought 2005 280 DA. Seems Michigan and federal rules call for a stern navigation light. My searay does not have one. Am I missing something?
I have a 2001 sundancer 260 and experiencing draining power even when the shore power is plugged in. 2 brand new marine deep cycle batteries installed. Any idea what could cause this?
2006 340 DA- Can anyone share advice on replacement of the 1.5" vacuum discharge hose from toilet to vac generator? The original hose is dry rotted and not holding vacuum. I have removed 96% of the glob of silicon from the hose on the cabin side of a...
Has anyone repowered Mercruiser 4.3L MPI Alpha with raw-water cooling and SmartCraft in the boat harness with 4.5L Alpha, RWC, non-ECT?
New CO Detector I am replacing the original CO detector in a ‘17 Sundancer that had a two-wire and a four wire plug. The new detector has only a red and black wire and I was wondering how to tie the two units together. One wire from the boat has a...
Thank you. That was very helpful. Yes, the cable is still installed. I think that I am going to try inserting weed wacker line before pulling the outer jacket.
Great forum. 2005 290 AJ. Smart gage beeps and reads “port engine pressure gage” after 15-20 mins running. Could this be oil pressure or block pressure sensor failure? Any suggestions? Thanks.
