I keep getting an Oxygen sensor Fault Code on my SR 260 Sundeck 2010. Changed an oxygen sensor but did not help. Any ideas or a good SR Mechanic in Westchester County NY. The alarm is driving me nuts every time it beeps but boat runs well, cool and ...
I was proud to upgrade to a SeaRay and chose the 21spx with the 4.3MPI motor. Our first outing was on a residential lake where we ran at No Wake speeds for 20 minutes, then 20mph for about 5 min, plus more No Wake zone. We docked for a visit and af...
2001 - 380 SeaRay aft cabin. Prop Pitch and Prop Specs Needed: Does anyone out there know what the prop pitch is for this boat and the recommended size of props. I cant find this information anywhere,Engine: VD-8.1 S MerCruiser® (T-370 hp - 276 kW) ...
Engine stops at idle... On my 2006 280 the starboard engine (320hp Merc) stops when I put her in idle. I can keep her going if I give a little more gas, but that's not practical when I'm entering the slip. Any suggestions on what to do? This is my fi...
Ok, I have a 290 Bowrider with twin 350Mag MPi and Bravo 1's and my starboard drive alamarm goes off and reservoir empty after several hours of run time. There does not apear to be any oil or milky issues in the bilge and once I trailered up the driv...
I have a 2005 Weekender 245 with a 350 Mag MPI that I keep on a trailer. When I first start the engine, either on the hose or in the water, it will overheat if I leave it at idle. It won pick up water at idle. If I give it throttle it will pick up th...
Hi all, I have a 1996 Sundancer 270 DA and need some help. by toilet flushes great however i am not getting any water to fill it. i have to use the potable water to fill the bowl. please can anyone point me in the right direction to get water from ...
Hi all, I have a 1996 Sundancer 270 DA and need some help. by toilet flushes great however i am not getting any water to fill it. i have to use the potable water to fill the bowl. please can anyone point me in the right direction to get water from ...
Where are all the screws located for the top of the panel? I have all visable ones out and the top half of the console is still tight. I have nuts falling off the ign. bracket ,multifunction panel etc.
