Where can I find the rollers for...
Where can I find the rollers for the entry door on a 87 39EC?
Where can I find the rollers for the entry door on a 87 39EC?
Hi everyone, not sure if this is allowed, I have decided to move on to a trawler and sell my Sea Ray 420 it’s a 1990 Sundancer with 3208 catapillar engines. Starboard top end rebuilt with new head gasket.Tons of new parts throughout yacht. I’m in Flo...
While running my Westerbeke 7.2BCGTC on my 2000 380DA under a typical full load (both A/Cs, TV, Stereo, air pump briefly), the microwave was used and suddenly something blew or tripped, and the boat lost all 120V power. The genset continued to run ...
I am replacing all of my electronics on my 2008 Sundancer 55 with all New Garmin ElectronicsAmazing how much wire and cable I have removed from the boat, many of which was not hooked up to anything I have everything removed that was for the old syste...
Wanted to let everyone know that we listed our 1999 560 sedan bridge for sale because we are moving to FL and I’ll boat differently there. It has the big CATs and Many upgrades throughout. Fresh water boat as well. It’s on YachtWorld as a “new arriv...
Wanted to share that we are selling our 1999 560 Sedan Bridge. Fresh water boat. Upgrades throughout. We are moving to FL and will be boating differently there. Reach out for info.
Looking for a 12 x 5 air intake grille which is located outside under the engine compartment body hood of the 2008 44DA,tried all the online options.
Help.. 02 510 SD.. replacing all lights with led.. no problems until... master stateroom closets.. no power to the lights. Festoon 24 volt halogen. Manual shows all lighting 24 volts dropped to 12 volts through converter. Found cockpit courtesy li...
Old boats are fun. The Quicksilver generator on my 1989 440 convertible has a worn out water pump. Can’t find a replacement or anyone who can rebuild because the housing is worn out. Going to replace the belt driven, impeller water pump , with an ...
I'm about to purchase a 390/40 Motor Yacht. Does anyone know how to access inside the swim platform to put in backing plates/nuts for a davit system? My 290 Sundancer was easy. The MY has an enclosed bustle swim platform. Thanks!