Bought a 2008 47 ft Sea Ray Fly Bridge and need some help converting the Dinette area in the fly bridge to a bed. Does the area where the table is used for the bed? If so how? Seems there is not enough cushions to fill that space and no support w...
Anyone know how to repair the pocket door tracks on forward state room without taking the walls apart?
removal of hockey pucks adhered to hardtop with PL3000.Original owner installed a crystalline solar panel by adhering 4 hockey pucks then screwing the panel in. I have upgraded since but have not been able to remove the hockey pucks and fear damagin...
Hi I have a L590 Fly 2017 - fitted with 3 pods. When I turn on the ignition keys I get the same error message for each of the 3 engines. It says: E-stop. check engine before next use. All three engines are dead. I have checked all three E-sto...
I have a 1989 440 Convertible, and there are hairline cracks all around the exhaust ports on both sides. Any idea what might have caused these and best way to fix. I think at the moment they are just cosmetic, and they are, of course above the wate...
I'm Looking at a 2008 47 Sedan Bridge and would like to know what is the bridge clearance. My boating area (Lake Erie) has couple rather low bridges and with the fluctuating water level it can be challenging. The owners manual says is 20' 3" to the ...
1997 400EC. Port bilge blower fan is inoperable although I know for a fact it the fan itself works. Have checked/replaced dash rocker switch and checked wires at circuit breaker panel. Wiring diagram shows the fans are wired through a bilge blower...
I have 40 sundancer. Does anyone know how to remove/adjust the helm seat. All adjustments seem to be frozen.
Mortis Latch part needed. We're Archimedes II, a 2004 390 Motor Yacht. I have a broken plastic bit on the cockpit wing port in the mortise latch. I'm hearing that it is three months to get a replacement. Anyone know where I can get my hands on a P...
After purchasing my 2001 450 EB in Maryland, I began moving it to my home port in Florida. I got as far as North Carolina before the Starboard engine had overheating issues. After 15 phone calls I finally found someone who could look at it. After ...
