Prop Pitch
Just put a Bravo Three on a 1990 27ft Sundancer looking for the correctProp Pitch
Just put a Bravo Three on a 1990 27ft Sundancer looking for the correctProp Pitch
I keep getting an Oxygen sensor Fault Code on my SR 260 Sundeck 2010. Changed an oxygen sensor but did not help. Any ideas or a good SR Mechanic in Westchester County NY. The alarm is driving me nuts every time it beeps but boat runs well, cool and ...
I was proud to upgrade to a SeaRay and chose the 21spx with the 4.3MPI motor. Our first outing was on a residential lake where we ran at No Wake speeds for 20 minutes, then 20mph for about 5 min, plus more No Wake zone. We docked for a visit and af...
Engine stops at idle... On my 2006 280 the starboard engine (320hp Merc) stops when I put her in idle. I can keep her going if I give a little more gas, but that's not practical when I'm entering the slip. Any suggestions on what to do? This is my fi...
Ok, I have a 290 Bowrider with twin 350Mag MPi and Bravo 1's and my starboard drive alamarm goes off and reservoir empty after several hours of run time. There does not apear to be any oil or milky issues in the bilge and once I trailered up the driv...
I have a 2007 Amberjack and the Engine Guardian system is giving several alarms. 1) Overspeed (I was only going ~6 knots), 2) low engine coolant pressure and 3) Overheat Engine Coolant Temp circuit. Then it put me into a reduced power mode. I alre...
1997 had the carb rebuilt over the winter and now my elec. choke works backwards. As the engine warms the choke closes, anyone had this problem?
2012 SEA RAY 260 SUNDECK. 95 hours. Trouble since 2014 when still under warranty. Spent over $2000 new fuel pumps, etc. Didn't solve problem. Engine still not running right. About every third time we use it, it will stall on our way bck to the d...
Hello. I have a 2003 280 Sundancer with 4.3MPI engines coupled to Alpha one Gen 2 mercruiser drives. I am having problems with engines stalling when docking. This is very frustrating and unsafe. I have changed shift cables, IAC valves and still have ...