Community Connection
Advice and support from fellow boaters
cancel
Showing results for 
Search instead for 
Did you mean: 

Conversations

Engine dies when throttle up

Bought 97 270 Sundancer with 7.4 Mercruiser and Bravo III few months ago. Ran OK for about 3 hours and now when I throttle up, engine dies. Had gas cleaned and checked for water and dirt, it was clean. Also replaced carburator. Filled tank with non e...

JCS by Guest Contributor
  • 1047 Views
  • 2 replies
  • 0 likes

low water pressure alarm

I have a 2010 280 SunDeck with ECT-350 MAG MPI DTS BR 3 (300 PHP) STERN DR.  I get a System Fault alarm when pulling back to idle.  With the water pressure showing on the SmartCraft, the water pressure drops to zero.  At speed the pressure is 10.5 to...

SasSea by Guest Contributor
  • 625 Views
  • 0 replies
  • 0 likes

1998 270 Sundancer Starboard Engine starting issue

I usually run my boat engines at least once a week and up until now have had no issues. I started the port engine and when I went to start the starboard engine the alarm sounds as normal but the engine does not turn over, as in it seems no voltage to...

Alarm

I have a 1999, 27' SeaRay Sundancer with twin 4.3 liter V-6 two barrel carb Mercruiser engines. (OL serial numbers).I have an intermittent alarm with no aparent pattern. Last weekend it did chirp three in a row one time. My temp gauge reads about 170...

I have a new to me, 2008 340 with...

I have a new to me, 2008 340 with twin 8.1 inboards.    I have been burning gas faster in port engine vs. Star, at a pretty significant rate.   Added 86 gallons to fill for port vs 72 for Starboard.   This has happened in this range 3 times now (stil...

I have a 2013 280DA 8.2 seacore...

I have a 2013 280DA 8.2 seacore Mag single engine and I am looking to replace the salon task lights in the berths with LED bulbs. Can anyone offer advice as to which type of bulb I should use. If possible, it would be great if someone can recommend a...

TVM: TAB A PRESS RANGE LOW error message

I have been getting this error message on my SmartCraft. 2012 Sea Ray 450 sedan bridge with 600 cummins and zeus drives. I have check the fluid and it is full on both trim tabs, but still get error message. Any thoughts on what to do proir to calling...

Macdaddy by Guest Contributor
  • 332 Views
  • 0 replies
  • 0 likes
Labels