Hi All! I own a 2008 SR 290 AJ. It is powered by twin 5.0 liter Mercruiser V-8s. I got a fuel injector error message in the display on the tachometer of one of the engines. The injectors and the fuel delivery rail were replaced. The plugs, ignition w...
Kudos to Don: The OxyClean removed the rust. I tried a variety of products to no avail. Here is what I did: I used the OxyClean gel, following the directions of applying it and letting it sit for 5-10 minutes. Then with a Scotch Bright non scratch s...
I own a '98 240 Sundancer with Mercruiser 5.0L. There's a slight smell of fuel in my cabin - source unknown, no visible leaks. Anyone ever deal with this?
2001 290 Sundancer I need to put a new screen on my bow hatch. It has the slide mechanism that allows you to slide and have full screen or full shade or half and half etc. someone put their foot through when the screen was in and it came off the rol...
Greetings Everyone: Hopefully someone has a suggestion for removing a rust stain from one of the seats at the helm. I am not sure what the actual material is, other than describing it as vinyl. It is the factory helm seat on a 2000 340. Thanks
Looking for information on why my generator and starboard engine stall and won’t restart after running at cruising speeds but stall at idle and won’t restart.
Both of my hour meters are screwed up, digits are missing sections and cannot be accurately read. Can the "true"hours run be retrieved electronically ??
Hi All,I just purchased a Lowrance hook2 fishfinder. It has a new transducer. I have 86 Sundancer with swimboard.Anybody know the best placement for the transducer? There is an old Garmin gps and another fishfinder over ten years old. Is it best to r...
Hey folks, I have another one.This past summer was a learning experience for me. I've been away from the water for 25 years and just bought my '01 , 310 DA last spring. I started noticing a "growling" noise in the port engine(area)Mechanic says it's...
Looking for the best way to clean color coated fenders with rub marks from other boats and docks. Any suggestions? Tried abrasive hand cleaners and they cut through sheen.
