Hello. I have recently acquired a 1988 sea ray seville with the 100 hp outboard motor. I'm currently getting no spark and my alarm system is going of. Engine is cold and oil Reservoir is filled. I would like to see if I could find a wiring diagram o...
98 330 DA with 2 30 amp inlets. I run a single cord to side of boat and then splitter into 2 inlets. Bottom or secondary line which powers air/heat and micro outlet is fine. Top line or main is indicating reverse polarity thus nothing working i.e. a...
Second run on our new 2022 SeaRay SPX 19, when shutting the power off to the battery I noted some water on the floor around the battery? Has anyone noticed this before, is this caused from slowing the boat down quickly, and water coming up over the s...
I have a '98 310 DA w/ twin 350 Mag engines w/ Velvet drive V drives. approx 575 hours on each, with recent oil change and tune up.I'm fairly new to the boat. Both engines run up fine to 4800 RPM's in Neutral.However, with both trans in gear, Starboa...
After phone calls to both SeaRay as well as local dealers...no luck in getting info on how to remove the attached seat backs from my 27 Sundancer.No wonder...the boat is built in two sections, and then glued together after the entire area above the h...
Hi! I have a 2000 48 sedan bridge with the washer/dryer combo unit. I can’t find any type of filter/lint screen to clean. Does it just not have one or am I missing it somewhere? Thanks in advance!
Hi SR owners,I have a 2009 310 Sundancer.My joy stick is not functioning. Vessel View says it’s no available. Canceled alarm history and it still won’t work.Any suggestions?
Who would I speak to about being a little disappointed with the fit and finish quality of my new 2022 boat?
Anyone have a link to the replacement bulb for the red navigation light on a 2001 Sundeck 240?
Hello readersI have a 2006 340DA Searay cruiser on which I must replace the 1.5" V- drive prop shaft and prop. Anyone know the current part number for the dripless shaft seal, or for a new internals for the seal? No markings that I can see, and se...
